GRAPHTEC LABELROBO LCX603 - Page 158

5-10
Chapter 5 Replacing Consumable Items
(1) Remove the media stocker from the printer body.
If replacing label materials during an operation, cut the label materials as shown in right-side diagram and take it out.
4UFQ
$VU
4UFQ
4UFQ
.FEJBTUPDLFS
(2) Clear away remaining label materials in the main body. Open the main unit front cover first, and then remove the
ribbon lever set.
4UFQ
4UFQ
3FNPWF
UIFSJCCPOMFWFSTFU
• When setting the label materials (media) and feeding the source, always do so when media assistance is
installed. Refer to "Setting Media Assistance" in "2.6 Loading Label Materials (media)" regarding setting
media assistance.
4UFQ
4UFQ
4UFQ
-FWFS
.FEJBBTTJTUBODF
$MJDL
,FFQUIFSJCCPOTUPDLFS
DPWFSPQFO
'BTUFOUIFMFWFShTCVMHF
JOUIFTMPU
• Make sure the ribbon stocker cover is open when feeding.