GRAPHTEC LABELROBO LCX603 - Page 206

7-10
Chapter 7 Troubleshooting
LCD Display Cause Solution
'
'
'
'
W 1 3 : P r i n t s i z e c h e c k
C o n f i r m C - u n i t p u s h
r o l l e r p o s i t i o n o r
t h e p r i n t d a t a .
The size set in the driver and the
media size set in the printer differ.
The size set in the driver and the media size set
in the printer differ.
Set the media size to be the setting in the driver.
Send DATA that corresponds to the set media
size.
'
'
'
'
W 1 4 : M e d i a l o a d c h e c k
T h e c a m l e v e r i s
n o t s e t .
S e t t h e c a m l e v e r !
The cam lever has not been set. The cam lever has not been set.
Set the cam lever.
'
'
'
'
W 1 5 : M e d i a l o a d c h e c k
T h e c a m l e v e r i s
s e t t i n g . R e l e a s e t h e
c a m l e v e r !
The cam lever has been set. When the media is supplied, the cam lever is
set.
Release the cam lever.
'
'
'
'
W 1 6 : P u s h r o l l e r
C o n f i r m t h e p u s h
r o l l e r p o s i t i o n .
The push roller has been set out of
the specification scope.
The push roller has been set out of the
specification scope.
Reset and confirm the push roller position.
'
'
'
'
W 1 7 : T h e w a s t e m e d i a
w i n d e r f u l l !
R e p l a c e t h e b o b b i n .
Y E S : E N T E R
*
The take-up is at capacity. The separator take-up is over capacity.
Replace the separator take-up bobbin.
'
'
'
'
W 1 8 : M e d i a w i n d e r
S e t w i n d e r b o b b i n
a n d p r e s s E N T E R . O r
p r e s s F 4 t o c o n t i n u e
Unit Menu = Separator: ON
The take-up bobbin has not been
set.
The take-up bobbin has not been set. Set the
take-up bobbin, or turn the functional setting
separator OFF.
'
'
'
'
W 1 9 : M e d i a w i n d e r
R e m o v e w i n d e r b o b b i n
a n d p r e s s E N T E R . O r
p r e s s F 4 t o c o n t i n u e
Unit Menu = Separator: OFF
The take-up bobbin has been set.
The functional setting and the take-up bobbin
setting do not agree. Remove the take-up
bobbin, or turn the functional setting separator
ON.
'
'
'
'
W 2 0 : E n d i n g o f M e d i a .
R e m o v e t h e r e m a i n i n g
m e d i a .
A n d s e t n e w m e d i a .
*
Media is over. Remove the remaining media and re-set the
media.
* When this error message occurs while performing copying, pressing the “NEXT” key will display the target number of
copies currently being printed. (This display will continue for as long as “NEXT” is being pressed, and will disappear
once the button is released.)