Safety Precautions
During a cutting/printing operation, do not touch the
roller, tool carriage, and other moving parts.
• Such action may cause human injury.
During a cutting/printing operation, be sure to keep
your hands, hair, and so forth away from the roller,
tool carriage, and other moving parts.
• Such action may cause human injury.
Even when the label printer is stopped, it may suddenly
start operating if it receives data, so be sure to keep
your hands, hair, and so forth away from the vicinity of
the roller, tool carriage, and other moving parts.
• Such action may cause human injury.
Do not connect the label printer to a non-rated power
supply.
• Use of a different supply voltage may result in electrical
shock or a fire hazard due to current leakage.
If the label printer generates smoke, is too hot, emits
strange odor, or otherwise functions abnormally, do
not continue using it. Turn off its power and unplug its
power cord from the electrical socket.
• Use of the label printer in such status may result in a fire
hazard or electrical shock.
• After confirming that smoke is no longer being generated,
contact your sales representative or nearest Graphtec
vendor to request repair.
• Never try to perform repair yourself.
Repair work by inexperienced
personnel is extremely dangerous.
Make sure that the label printer is grounded.
• If the printer is not grounded, the operator could suffer an
electrical shock in case of current leakage.
• Always make sure the ground connection is in place
before connecting the power plug into the power supply. In
addition, always disconnect the power plug from the power
supply when removing the ground connection.
Do not use the label printer in a location where it will
be exposed to water, rain or snow.
•Use of a different supply voltage may result in electrical
shock or a fire hazard due to current leakage.
#FXBSFPG
FMFDUSJDBMTIPDL
Do not disassemble or remodel the label printer.
• Use of a different supply voltage may result in electrical
shock or a fire hazard due to current leakage.
• Contact with the high-voltage parts within the label printer
may cause electrical shock.
• Contact your sales representative or nearest Graphtec
vendor to request repair.
To Next Page
Loading...