GRAPHTEC LABELROBO LCX603 - Page 5


Safety Precautions
Safety Precautions
Do not use the power cord if it is damaged.
• Use of a damaged cord may result in electrical shock or a
fire hazard due to current leakage.
• Replace the power cord with a new one.
%JTDPOOFDUQPXFSQMVH
GSPNPVUMFU
Handle cutter blades with care.
• Avoid direct contact with the cutter blade. Touching the
blade with your bare hand may cause injury.
• During a cutting operation, keep away from the cutter
blade.
/PUPVDIJOH
Do not use or store the label printer in a location
exposed to direct sunlight or the direct draft of an air
conditioner or heater.
• Such locations may impair the performance of the label
printer.
1SPIJCJUFE
Do not use or store the label printer in an excessively
dusty or humid location.
• Such locations may impair the performance of the label
printer.
1SPIJCJUFE
Do not place a coffee cup or any other receptacle
containing water or other fluid on top of the label
printer.
• Fluid falling inside the label printer may cause electrical
shock or a fire hazard due to current leakage.
"WPJEXBUFS
#FXBSFPG
FMFDUSJDBMTIPDL
Do not install, use, or store the label printer in a
location subject to excessive mechanical vibration or
electrical noise.
• Such locations may impair the performance of the label
printer.
1SPIJCJUFE
Do not allow dust or metallic matter to adhere to the
power plug.
• Use of a different supply voltage may result in electrical
shock or a fire hazard due to current leakage.
1SPIJCJUFE
#FXBSFPG
FMFDUSJDBMTIPDL