GRAPHTEC LABELROBO LCX603 - Page 47

2-15
Chapter 2 Preparation for Printing
(5) Set the media assistance. Makes sure the screw pin fits firmly in the slot.
Please confirm that the screw pins are properly fitted.
5IFQJOTNVTUCF
QSPQFSMZGJUUFE
.FEJBBTTJTUBODF
(6) Push the lever and slowly and quietly return media assistance to the main body. Push until there is a clicking
sound.
Push and secure the lever so that it is firmly fastened in the slot.
Keep the ribbon stocker cover open.
• Insert media assistance deep into the main body.
• Make sure the lever's bulge is fastened in the slot.
4UFQ
4UFQ
-FWFS
,FFQUIFSJCCPOTUPDLFS
DPWFSPQFO
'BTUFOUIFMFWFShTCVMHF
JOUIFTMPU
$MJDL
When setting the label materials (media) and feeding the source, always do so when media assistance is installed.
After you have finished feeding the label materials, refer to "2.8 Setting the Ink Ribbon" when removing media assistance
and setting the ribbon stalker.