GRAPHTEC LABELROBO LCX603 - Page 48

2-16
Chapter 2 Preparation for Printing
Loading Label Materials (media)
When setting the label materials (media) and pushing the FEED key when the source is fed, do so
when media assistance is installed. Refer to "2.8 Setting the Ink Ribbon".
(1) Keep the press lever, cam lever, separator, and separator suppression unit open.
Cam lever
Separator
Press lever
Separator suppression unit
Step 1
Step 2
Step 3
Step 4
Refer to the below diagram for when the press lever, cam lever, separator, and separator
suppression unit are set (closed) and when they are open.
$BNMFWFS
1SFTTMFWFS
4FQBSBUPSTVQQSFTTJPOVOJU
0QFODPOEJUJPO
0QFODPOEJUJPO
$MPTFEDPOEJUJPO
$MPTFEDPOEJUJPO