GRAPHTEC LABELROBO LCX603 - Page 49

2-17
Chapter 2 Preparation for Printing
(2) Press the FEED key following the instructions from the control panel when the label materials are set in the media
stocker.
The label materials will be sent to the feed roller and stop.
The below message will display if the label materials are not set. Set the label materials in the
media stocker. Refer to "2.5 Setting Label Materials
(media)
".
'
'
'
'
L 0 1 : N o M e d i a
S e t t h e m e d i a i n t o
s t o c k e r .
T h e n p r e s s F E E D k e y .
Label materials tip
(3) Pass the label materials straight through the space between the feed roller and press roller, and close the press
lever.
• Set the label material exactly straight along the scale seal.
• The below message will display when the label materials are fed.
'
'
'
'
L 0 2 : P a s s t h e m e d i a
t h r o u g h P r e s s - r o l l e r
a n d c l o s e t h e l e v e r .
T h e n p r e s s F E E D k e y .
1SFTTMFWFS
4DBMFTFBM
4UFQ
4UFQ
4UFQ