2-18
Chapter 2 Preparation for Printing
(4) Press and hold down the FEED key, and pull out the label materials fully while extracting it to the upper side.
Once it has been fully extracted, release the FEED key.
• The below message is shown when the FEED key is pressed.
'
'
'
'
'
'
'
'
L 0 3 : P r e s s F E E D k e y
f o r f e e d i n g a n d
s e t t i n g t h e m e d i a .
L 0 3 : P r e s s E N T E R k e y
w h e n f i n i s h e d
s e t t i n g t h e m e d i a .
"MUFSOBUJOH
• Refer to "2.11 Using the Laminate" for how to set the laminate material.
• Setting is possible when pulling out the label materials, even through the cutter unit.
Step 1
Pull upwards
Step 2
Pull up
till here
To Next Page
Loading...
