GRAPHTEC LABELROBO LCX603 - Page 52

2-20
Chapter 2 Preparation for Printing
(6) Pull the label materials from the outlet side, and straighten them as they are being pulled. (Step 1)
While it is straight, close the cam lever while pulling the label materials from the outlet side. (Step 2)
Close the separator suppression unit. (Step 3)
• Set the label material exactly straight along the scale seal.
• Make sure the roller position of the separator unit outlet matches both sides of the label
materials.
$BNMFWFS
4UFQ
4UFQ
4DBMFTFBM
4FQBSBUPSTVQQSFTTJPOVOJU
0VUMFUSPMMFS
4UFQ
(7) Close the separator while pulling the label materials from the outlet side.
Separator
Step 1
Step 2