2-21
Chapter 2 Preparation for Printing
(8) Press the ENTER key when it is possible to set the label materials at the time the below message is shown.
'
'
'
'
'
'
'
'
L 0 3 : P r e s s F E E D k e y
f o r f e e d i n g a n d
s e t t i n g t h e m e d i a .
L 0 3 : P r e s s E N T E R k e y
w h e n f i n i s h e d
s e t t i n g t h e m e d i a .
"MUFSOBUJOH
(9) When the below confirm screen appears, press ENTER.
When setting each item, set and press enter as according to the message. (Press ENTER to confirm even when
the separator and laminate are not set.)
■
Confirm Separator
'
'
'
'
L 0 4 : C o n f i r m . W a s t h e
w i n d e r b o b b i n s e t ?
Y E S : E N T E R
■
Confirm Laminate
'
'
'
'
L 0 4 : C o n f i r m . W a s t h e
l a m i n a t e i n s t a l l ?
Y E S : E N T E R
(10) The below message will appear.
Set the dancer roller. (Refer to the next items (11) and (12).)
'
'
'
'
L 0 4 : C o n f i r m . W a s t h e
d a n c e r r o l l e r s e t ?
I n i t i a l i z e w i l l
s t a r t . Y E S : E N T E R
(11) Set dancer roller 1. Insert both sides of the dancer roller into the slot that accepts it.
*Set dancer roller 1 on the side with the red mark.
Dancer roller 1
(Has a red ring mark on both sides)
Red mark
There are two types of dancer rollers. Don't mistake one for the other when setting them.
%BODFSSPMMFS
5IFSFBSFSFESJOHTPOCPUITJEFT
6TFEJOCFUXFFOUIFQSFTTSPMMFSBOE
DVUUFSVOJU
%BODFSSPMMFS
5IFSFJTOPSFESJOH
6TFEJOCFUXFFOUIFDBTTFUUFVOJU
BOEUIFTFQBSBUPSVOJU
3FESJOH
To Next Page
Loading...