GRAPHTEC LABELROBO LCX603 - Page 61

2-29
Chapter 2 Preparation for Printing
(3) Pull the stopper lever situated on the center back slightly, and pull the ribbon cassette slowly and gently.
4UFQ
1VMMUIFTUPQQFSMFWFS
POUIFCBDLTMJHIUMZ
4UFQ
(4) Set the ink ribbon flange in the ink ribbon.
When peeling the tape, be careful not to peel the film section of the ribbon.
• Push so that there is no opening in between the paper tube and ink ribbon flange.
• The ink ribbon can be set on either side of the ink ribbon flange as they all are the same.
• When exchanging the ink ribbon in between, set the cutout in the mark.
• Roll and set the transparent section of the ink ribbon preliminarily.
$VUPVUTFDUJPO
"
1SJOUFETJEF
*OLSJCCPOGMBOHF
/PUZFUQSJOUFETJEF
1SJOUFETJEF /PUZFUQSJOUFETJEF
(5) Expand the ink ribbon.
/PUZFUQSJOUFETJEF
1SJOUFETJEF
5IFTJEFXIJDISPMMTUIFUSBOTQBSFOUQBSU
XIFOUIFSJCCPOJTOFX