GRAPHTEC LABELROBO LCX603 - Page 74

2-42
Chapter 2 Preparation for Printing
(2) Remove the laminate stocker flange. The object with the short shaft is the laminate stocker flange.
Set the gear side in front.
(3) In order to adjust to fit the laminate material width, release the lock from the flange and shift the shaft.
4UFQ
4UFQ
4UFQ
1SFTTUIF164)TFDUJPO
(4) Determine the position of the flange to match the laminate material width.
The width of the settable laminate materials are 50, 60, 70, 80, 90, 100, 110 mm.
-BNJOBUFNBUFSJBMXJEUINN
  r r r r r r r rr r
(5) Lock in the shaft groove and set the flange.
4UFQ
4UFQ