2-43
Chapter 2 Preparation for Printing
(6) Set the laminate materials and install the flange.
Set it so that the laminate materials are the revolute.
Push so that there is no opening in between the form tube and flange.
• During set-up, be careful not to confuse the revolute with the involution.
• Make sure the set laminate materials do not slack.
• There is the possibility of inclining to one side if media glue attaches to the inside of the flange.
Please clean regularly. (Refer to "6.12 Cleaning Media Stocker & Media Stocker Flange".)
(7) Remove the laminate winder bobbin flange. (The flange on the gear-side is fastened.)
The smaller black gear is for the laminate winding.
(8) Install the flange into the form tube of the laminate winder bobbin. Push so that there is no opening in between the
form tube and flange.
To Next Page
Loading...