GRAPHTEC LABELROBO LCX603 - Page 76

2-44
Chapter 2 Preparation for Printing
(9) Install the laminate stocker and laminate winder bobbin. Push until there is a clicking sound.
$MJDL
$MJDL
(10) Pull out the laminate material.
Cut the adhesive area of the laminate materials approximately 150 mm from the forefront.
Cut and peel the adhesive section of the laminate tip.
Set-up is easier when the adhesive section of the label material is cut first.
4UFQ
0OMZDVU
UIFBEIFTJWFTFDUJPO
"QQSPYNN
4UFQ
4UFQ