GRAPHTEC LABELROBO LCX603 - Page 77

2-45
Chapter 2 Preparation for Printing
(12) Apply the laminate (adhesive section) straight over the laminate bar and laminate tension bar to the label material.
Fold back the backing sheet side from the laminate tension bar and attach to the laminate winder bobbin with tape.
If the laminate material backing sheet is overly sagging, twist the laminate winder bobbin to wind it up.
Set the dance roller exactly straight along the scale seal.
-BNJOBUFUFOTJPOCBS
-BNJOBUFCBS
"EIFTJWFTFDUJPO
#BDLJOHTIFFUTFDUJPO
4UFQ
"UUBDIUIFCBDLJOHTIFFUTFDUJPO
UPUIFMBNJOBUFXJOEJOHGMBOHF
VTOHUBQF
4UFQ
"QQMZUPUIFMBCFMNBUFSJBM
UPUIFBEIFTJWFTFDUJPO
If the laminate material backing sheet is overly sagging, twist the laminate winder bobbin to
wind it up. Since there is a rotational direction in the laminate winder bobbin, refer to the below
illustration when winding.
PresstheFEEDkey,andalwaysmakesuretherearenowrnkleswhenfeedngthelabelmateralandthatthebackng
sheetswoundnthewnderbobbnwhenthelamnatemateralsfed.
When the below message is displayed, release the ribbon lever set-up.
'
'
'
'
W 0 4 : L o a d i n g c h e c k
R i b b o n l e v e r i s s e t .
C a n n o t f e e d .
Y E S : E N T E R