GRAPHTEC LABELROBO LCX603 - Page 92

3-6
Chapter 3 Printer Driver
(8) Use the USB cable to connect this device to your computer, and then turn on the power to this device.
64#DBCMF
$PNQVUFS
→
(9) The device driver will be installed.
↓
If the installation is successful, "Graphtec LCX603" will display within "Start"
→
"Devices and
Printers" using Windows 7.
When connecting with a network cable
(5) Select Interface.
Select "Standard TCP/IP Port: (Network)" from the pull-down list and click on "Next".
(6) Use the network cable to connect this device to your computer, and then turn on the power to this device.
A CAT5 (Category 5) network cable is recommended.
/FUXPSL-"/DBCMF
/FUXPSL
$PNQVUFS
→