3-5
Chapter 3 Printer Driver
Next, Select a port name. Select according to the utilized interface.
Select the "port name" according to the utilized interface.
Interface Port Step
Connect with USB cable
USB P3 - 5
Connect with Network Cable
TCP/IP P3 - 6
Output the plotting data to a file without
connecting with the main unit
FILE —
When connecting with USB cable
(5) Select Interface.
Select "USB" from the pull down list and click "Next".
The below message will appear.
(6) Install the driver software.
Click on the checkbox entitled "Always trust software from ‘Graphtec Corporation’" to place a checkmark inside it
and click on "Install".
(7) The below screen will appear. Click "OK".
To Next Page
Loading...
