3-10
Chapter 3 Printer Driver
[Graphics] Tab
When you click on the [Graphics] tab, the following screen appears.
Print Head ......................Displays the head number output settings of the label data color made by the application. The
display changes through the color selection set in "Setting the Color".
The body heads are installed as Head 1, Head 2, and Head 3 from bottom to top with Head 3
being the basic one.
Setting the Color ............Selects the output color of Head 1, Head 2, and Head 3. The available colors are seven: black,
red, blue, green, magenta, cyan, and yellow. The color with a check next to it is selected.
The color specified here is the application color. The actual printing color is the color of the set
ink ribbon.
Other Color Outputs ......To be selected when using a label color different from the seven display colors.
Selection among Heads 1 - 3 can be made, but even if Head 3 is not selected, it is used in the
cut mark printing, so please set black ribbon in Head 3.
Select Cutline .................Specifies the color of the line data, which carries out the label's half-cutting. The cutline
recognized by the driver is the color specified here and is only the thinnest line that can be set
in the application.
The exact wording differs according to the application, but please use the thinnest line
thickness such as zero and make the cutline as a hairline.
When thin lines with the same colors as those set for the cutlines are present on the data,
depending on the application being used, said lines may be perceived as being cutlines and
cut as a result. In such instances, either widen the width of the lines that were excessively cut,
or change the data-based color of the lines set for the cutlines, followed by changing the color
under “Select Cutline” in the driver to match the actual cutlines.
Color Settings ................When clicking "Select Cutline", "Setting the Color" will be displayed. You can then choose from
the basic colors, or add a new one through "Add Color".
The allowable value range for a given color is set as ± 50 as default.
Allowable Value Range ..The allowable value range with respect to color setting 255 is displayed, which can then be set
in the 0 - 100 range.
For example, if the value is set to 50, up to 205 is recognized as a set color.
To Next Page
Loading...