GRAPHTEC LABERLROBO DLC1000 - Page 16

C-2
2.3 Using the Control Panel ................................................2-6
Indicator Lamps ..............................................................2-6
Panel Keys ..................................................................2-6
Reading the Screen (LCD) ......................................................2-7
2.4 Turning on the Power ..................................................2-9
2.5 Setting the Label Material (Media) ......................................2-11
Label Material (Media) Type ..................................................2-11
Set the Label Material (Media) ..................................................2-12
When Using the Media After Printing in DLP1000 .................................2-16
Set the Label Material (Media) in the Machine .....................................2-18
Feed the Label Material (Media) ................................................2-20
<When using the separator (weeding)> .........................................2-25
<When the winding roll holder is used> .........................................2-32
<When the winding roll holder is not used> ......................................2-35
2.6 Aligning the Push Rollers .............................................2-39
Aligning the Push Rollers ......................................................2-39
2.7 Using the Laminate ...................................................2-40
2.8 Using the Cross Cutter ................................................2-48
2.9 Using the Slitter .....................................................2-49
Combinations of Slitter Position ...............................................2-50
When using the slitter .......................................................2-51
2.10 COND/TEST Key .....................................................2-55
Screen Flow Through COND/TEST Key. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-55
2.11 Select the Tool Conditions .............................................2-56
LCD Display ..............................................................2-56
Selecting the Tool Condition No. ..............................................2-56
Setting Tool Condition ........................................................2-58
Setting the Tool .............................................................2-60
Setting the Offset ............................................................2-61
Setting the Speed ...........................................................2-62
Setting the Force ............................................................2-63
Setting the Acceleration .......................................................2-64
Setting the Cross Cut .........................................................2-65
Setting the Rewind (REWIND) ..................................................2-66
Setting the Tangential Emulation (TANGENTIAL MODE) .............................2-67
Setting the Length of Overcuts (OVERCUT) .......................................2-68
Outline of Tangential Emulation (TANGENTIAL MODE) ............................2-70
2.12 Adjusting the Blade Length ............................................2-71
2.13 Running Cutting Tests ................................................2-72
Cutting Test ................................................................2-72
To make 1 cut with set value (CUT TEST : BASIC) ................................2-72
When Cutting the Desired Rounded Rectangle (Label test 4 sheets) ..................2-73
&RQÀUPWKH5HVXOWVRIWKH&XWWLQJ7HVW ...........................................2-75
Adjustment of Offset ........................................................2-75
Adjustment for Half Cutting ...................................................2-75
2.14 Stop during operation ................................................2-76
2.15 Display Cutting Area. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-77