GRAPHTEC LABERLROBO DLC1000 - Page 17

C-3
Chapter 3 Driver Software
3.1 Driver Software .......................................................3-2
Driver Software .............................................................3-2
3.2 Driver Software Operation ..............................................3-3
Chapter 4 Menu Operation
4.1 Display When the Power is Turned On ....................................4-2
4.2 Display During Processing .............................................4-3
4.3 Display During Feeding (Media) .........................................4-4
4.4 Menu Items ..........................................................4-5
4.5 COPY / ENDING FEED .................................................4-6
4.6 SEARCH START-MARK ................................................4-8
4.7 CHANGE SETTINGS ...................................................4-9
4.8 NUMBER OF POINTS .................................................4-10
4.9 SENSING SPEED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-12
4.10 SENSOR OFFSET ADJUST ............................................4-14
4.11 PAPER-WEIGHT .....................................................4-17
4.12 BAR CODE ..........................................................4-19
If the bar code does not match ................................................4-21
4.13 FRAME CUT .........................................................4-22
4.14 OFFSET FORCE .....................................................4-24
4.15 DISTANCE ADJ. ......................................................4-25
4.16 LENGTH UNIT .......................................................4-27
Chapter 5 Setting the Interfaces
5.1 SETTING INTERFACE ..................................................5-2
USB Interface ..............................................................5-2
Network (LAN) Interface ......................................................5-2
5.2 I/F LAN ..............................................................5-3
DHCP settings .............................................................5-4
IP address setting ...........................................................5-5
Subnet mask setting .........................................................5-6
Gateway setting ............................................................5-7
MAC address display ........................................................5-8
Chapter 6 Troubleshooting
6.1 Troubleshooting ......................................................6-2
The printer does not work when the power is on ...................................6-2
When an Error Message is Displayed ...........................................6-2
When Operation is Strange ...................................................6-3
When Cut Results Are Poor ...................................................6-4
6.2 Error Messages .......................................................6-5
6.3 Warning Messages ....................................................6-7