Groove 3RD WAVE - Using Chord Memory

96 Unison Groove Synthesis
Legato: On, Off, Slide — Enables and disables Legato mode. If Legato
is on, holding a note and playing additional notes will not retrigger the
envelopes (until you release the rst note). If Legato slide is on, glide is
not applied to individual notes, but only when you hold a note and play
additional notes.
Poly Count: off, 2, 3, 4, 6, 8, 12 — Sets Poly Unison mode on. The
number sets the polyphony (that is, how many notes you can play at one
time). When set to
off, Poly Unison mode is disabled.
To use Unison:
1. Press the unison button on the front panel.
2. In the display menu, use soft knob 2 to choose the number of voices to
stack.
3. To detune the oscillators while in unison, use soft button 3 to set the
amount of detuning between voices.
Using Chord Memory
With Chord Memory, hold down a chord on the keyboard, press the unison
button, and the 3rd Wave memorizes the notes of the chord. Single notes
played on the keyboard will then trigger all notes of the stored chord, trans-
posing them as you play up or down the keyboard.
If you save a program that uses chord memory, the chord is saved with
the program. Unison can be set individually for each part in a multi-part
program.
To use chord memory:
1. Hold down a chord on the keyboard.
2. Press the
unison button. The chord voicing is memorized. Play a few
notes to listen to the result.
3. If you save the program, the unison chord memory is saved with it.