31
3rd Wave User Manual
Wave Envelope
14. Be sure to turn up the level of each oscillator so that you can hear it.
Additionally, in the wave envelope section, enable the Osc 1, Osc 2, or
Osc 3 button for the oscillator wave envelope that you want to edit.
15. Finally, make sure that the on button is enabled/lit so that the wave
envelope is applied to the oscillators. If it is not on, the oscillator
waveforms are not swept by the envelope. Instead they generate only
the single-cycle waveform selected with the wavetable and wave offset
controls.
Wave Envelope Menu Parameters
ENV GRAPH: This toggles the display between a graphical representation of the
Wave Envelope and the various controls associated with the Wave Envelope.
COPY TO ALL: Copies the Wave Envelope of the currently selected oscillator
all oscillators.
LOOP ON: Enables wave envelope looping. When on, the wave envelope
will repeatedly cycle through the current wavetable as long as a key is held
down.
LP START PT: Selects the envelope stage at which wave envelope looping begins.
RELEASE PT: Selects the envelope stage at which wave envelope looping ends.
LEFT ARROW: On the graphic envelope display, pushing this soft button
selects the envelope stage to the immediate left of the currently selected
position. The wave position can then be edited with soft knob 3.
RIGHT ARROW: On the graphic envelope display, pushing this soft button
selects the envelope stage to the immediate right of the currently selected
position. The wave position can then be edited with soft knob 3.
To Next Page
Loading...