VARIABLES USAGE
#3002 Hour timer
#3003 Single block suppression
#3004 Override control
#3006 Programmable stop with message
#3011 Year, month, day
#3012 Hour, minute, second
#3020 Power on timer (read only)
#3021 Cycle start timer
#3022 Feed timer
#3023 Present part timer
#3024 Last complete part timer
#3025 Previous part timer
#3026 Tool in spindle (read only)
#3027 Spindle RPM (read only)
#3028 Number of pallet loaded on receiver
#3030 Single Block
#3031 Dry Run
#3032 Block Delete
#3033 Opt Stop
#3201-#3400 Actual Diameter for tools 1 through 200
#3401-#3600 Programmable coolant positions for tools 1 through 200
#3901 M30 count 1
#3902 M30 count 2
#4000-#4021 Previous block G-Code group codes
#4101-#4126 Previous block address codes
Note: Mapping of 4101 to 4126 is the same as the alphabetic addressing
of “Macro Arguments” section; e.g. the statement x1.3 sets variable #4124
to 1.3. The mapping of the axes are x=1, y=2, … b=5, for example, the Z
machine coordinate system variable would be #5023.
VARIABLES USAGE
#5001-#5005 Previous block end position
#5021-#5025 Present machine coordinate position
#5041-#5045 Present work coordinate position
#5061-#5069 Present skip signal position - X, Y, Z, A, B, C, U, V, W
#5081-#5085 Present tool offset
#5201-#5205 G52 Work Offsets
#5221-#5225 G54 Work Offsets
#5241-#5245 G55 Work Offsets
#5261-#5265 G56 Work Offsets
To Next Page
Loading...
