Tool Holder Assembly
Tool holders and pull studs must be in good condition and tightened together
with wrenches or they may stick in the spindle. Clean the tool holder body (the
part that goes into the spindle) with a lightly oiled rag to leave a lm, which will
prevent rusting.
.
Install a tool into the tool holder as instructed by the tool manufacturer.
to o l ch a n G e r
There are two types of tool changers available for the Haas mills; these are the
side mount tool changer and the umbrella style. Both types are commanded in
the same manner, but each one is set up differently.
Before loading tools the mill must be zero returned (power up restart button),
which should have been done at machine power up.
The tool changer is manually operated using the tool release button and the
ATC FWD and ATC REV buttons. There are two tool release buttons; one on
the side of the spindle head cover and the second on the keypad.
To Next Page
Loading...
