Haas 96-8000 - VR-Series Air Filter

255
96-8000 Rev AC
May 2010
Maintenance
Annually
• Replace the oil in the three (3) areas of the head:
For the areas on either side of the spindle head (A-axis), remove the drain plug
(4 BHCS) and drain the oil. Note: Remove the plug closest to the front on the
left side of the head, and the plug towards the rear of the right side of the head.
Fill the two areas with Mobil SHC-634 as described in the “Monthly” section
above.
B-Axis For the area at the rear of the spindle head, remove the 1/4” NPT pi-
peplug with an Allen wrench and drain the oil. Note: The plug is near the center
of this rear area. Fill with Mobil SHC-634 as described in the “Monthly” section
above.
.
1
2
3
Drain Plug Locations
Fill Port 1
Fill Hole Locations
Remove Sight
Glass to Fill
Remove
Cover Plates
(Both Sides)
Fill Port 3
Fill Port 2
vr-Se r i e S ai r fi l t e r
The VR mills are equipped with an air lter (P/N 59-9088) for the motor hous-
ing. The recommended replacement interval is monthly, or sooner depending
on the machining environment.
The air lter is located on the rear of the head cover. To remove the air lter,
simply pull up on the lter; the lter will slide upward out of its bracket. To
replace the lter, slide in the new air lter, oriented properly to lter air into the
motor housing. Filter air-ow direction is determined by a sticker on the re-
placement lter.