155 - Load Pocket Tables
This setting should only be used when a software upgrade is performed and/or
memory has been cleared and/or the control is re-initialized. In order to replace
the contents of the side-mount tool changer pocket tool table with the data from
the le, the setting must be ON.
If this setting is OFF when loading an Offset le from a oppy disk or RS-232,
the contents of the Pocket Tool table will be unaltered. Setting 155 automati-
cally defaults to OFF when the machine is turned on.
156 - Save Offset with PROG
Turning this setting On will have the control save the offsets in the same le as
the programs, but under the heading O999999. The offsets will appear in the
le before the nal % sign.
157 - Offset Format Type
This setting controls the format in which offsets are saved with programs.
When it is set to A the format looks like what is displayed on the control, and
contains decimal points and column headings. Offsets saved in this format can
be more easily edited on a PC and later reloaded.
When it is set to B, each offset is saved on a separate line with an N value and
a V value.
158,159,160 - XYZ Screw Thermal COMP%
These settings can be set from -30 to +30 and will adjust the existing screw
thermal compensation by -30% to +30% accordingly.
162 - Default To Float
When this setting is On, the control will add a decimal point to values entered
without a decimal point (for certain address codes.) When the setting is Off,
values following address codes that do not include decimal points are taken
as machinists notation (i.e., thousandths or ten-thousandths.) This setting will
exclude the A value (tool angle) in a G76 block. Thus, the feature applies to the
following address codes: X, Y, Z, A, B, C, E, F, I, J, K, U, W
A (except with G76)If a G76 A value containing a decimal point is found during
program execution, alarm 605 Invalid Tool Nose Angle is generated.
D (except with G73)
R (except with G71 in YASNAC mode)
Value entered With Setting Off With Setting On
In Inch mode X-2 X-.0002 X-2.
In MM mode X-2 X-.002 X-2.
Note that this setting affects the interpretation of all programs entered either
manually or from disk or via RS-232. It does not alter the effect of setting 77
Scale Integer F.
To Next Page
Loading...
