Haas 96-8000 - Additional Tooling Set-Up

60
96-8000 Rev AC
May 2010
1. Load the tool in the spindle.
2. Press Handle Jog (A).
3. Press .1/100. (B) (The mill will move at a fast rate when the handle is
turned).
4. Select between the X and Y axes (C) and handle jog (D) the tool near the
center of the part.
5. Press +Z (E).
6. Handle jog (D) the Z axis approximately 1” above the part.
7. Press .0001/.1 (F) (The mill will move at a slow rate when the handle is
turned).
8. Place a sheet of paper between the tool and the work piece. Carefully move
the tool down to the top of the part, as close as possible, and still be able to
move the paper.
9. Press Ofset (G).
10. Press Page Up (H) until the page with “Coolant - Length - Radius at the top
and scroll to tool #1.
11. Cursor (I) to Geometry for position #1.
12. Press Tool Ofset Mesur (J).
This will take the Z position located in the bottom left of the screen and put it at
the tool number position.
CAUTION! The next step will cause the spindle to move rapidly in the Z axis.
.
B
FD
I
K
C
HEJ G
A
Tool Length
is measured
from the tip
of thetool
to thetop of
thepartwith
theZaxis at
its home
position.
TipofTool
Topof Part
13. Press Next Tool (K).
Additional Tooling Set-up
There are other tool set-up pages within the Current Commands. Press Curnt
Comds and then use the Page Up/Down buttons to scroll to these pages.
The rst is the page with “Spindle Load” and “Vibration” at the top of the page.
The programmer can add a tool load limit for spindle load and vibration. The
control will reference these values and can be set to do a specic action should