234
96-8000 Rev AC
May 2010
908 - REMOTE SHARE PATH
The name of the shared network folder. After a host name is selected, to re-
name the path, enter the new and press the WRITE button.
NOTE: Do not use spaces in the PATH eld.
909 - USER NAME
This is the name used to logon to the server or domain (using a user domain
account). The machine must be turned off and back on for changes to this
setting to take effect. User Names are case sensitive and cannot contain
spaces.
910 - PASSWORD
This is the password used to logon to the server. The machine must be turned
off and back on for changes to this setting to take effect. Passwords are case
sensitive and cannot contain spaces.
911 - ACCESS TO CNC SHARE (OFF, READ, FULL)
Used for the CNC hard drive read/write privileges. OFF stops the hard drive
from being networked. READ allows read- only access to the hard drive. FULL
allows read/write access to the drive from the network. Turning off both this set-
ting and Setting 913 will disable network card communication.
912 - FLOPPY TAB ENABLED
This turns access to the USB oppy drive off/on. When set to OFF, the USB
oppy drive will not be accessible.
913 - HARD DRIVE TAB ENABLED
Turns access to the hard drive off/on. When set to OFF, hard drive will not be
accessible. Turning off both this setting and CNC Share (Setting 911) will dis-
able network card communication.
914 - USB TAB ENABLED
Turns access to the USB port off/on. When set to OFF the USB port will not be
accessible.
915 - NET SHARE
Turns access to the server drive off/on. When set to OFF access to the sever
from the CNC control is not possible.
916 - SECOND USB TAB ENABLED
Turns access to the secondary USB port off/on. When set to OFF the USB port
will not be accessible.
To Next Page
Loading...
