Haas 96-8000 - G155 5-Axis Reverse Tap Canned Cycle (Group 09)

192
96-8000 Rev AC
May 2010
G155 5-Axis Reverse Tap Canned Cycle (Group 09)
G155 only performs oating taps. G174 is available for 5-axis reverse rigid tap-
ping.
E Species the distance from the start position to the bottom of the
hole
F Feedrate in inches (mm) per minute
L Number of repeats
A A-axis tool starting position
B B-axis tool starting position
X X-axis tool starting position
Y Y-axis tool starting position
Z Z-axis tool starting position
S Spindle Speed
A specic X, Y, Z, A, B position must be programmed before the canned cycle
is commanded. This position is used as the “Initial Start position”.
The control will automatically start the spindle CCW before this canned cycle.
.
G155 5-AxisReverse Tapping Canned Cycle
E
G98Start
Position
G98/G99
E
Start Position
G99 RapidPlane
Z Axis position
between holes
Feed
Rapid Move
Beginor end
of Stroke
G161 5-Axis Drill Canned Cycle (Group 09)
E Species the distance from the start position to the bottom of the
hole
F Feedrate in inches (mm) per minute
A A-axis tool starting position
B B-axis tool starting position
X X-axis tool starting position
Y Y-axis tool starting position
Z Z-axis tool starting position