4. Add Mobil Mobil SHC 625 gear oil until the oil level is half way up the sight
glass.
5. Run a spindle warm-up and check for leaks.
hS 3/4/6/7 38-to o l to o l ch a n G e r Ma i n t e n a n c e
Six Months
• Lubricate the Magazine Drive Gear, Tool Pot and Changer Slide Rack us-
ing red grease:
• Lubricate the Arm Shaft using Moly grease.
Annually
• Lubricate the Changer Slide Linear Guide with red grease.
Tool Pot Chain Tension
The tool pot chain tension should be checked regularly. Chain tension adjust-
ment is performed in the lower left area of the magazine. Loosen the four
M12x50 SHCS from the front of the magazine. This will allow the plate to
move. Loosen the hex lock nut on the shaft and tighten the shaft using the hex
bolt. Lock in the adjustment with the hex lock nut, and retighten the four 12x50
SHCS. Tensioning will not change the indexed pot location, but check the align-
ment between the manual tool push cylinder and the tool pot.
ec-Se r i e S Pa l l e t ch a n G e r ro t a r y ta b l e
Oil Replacement
EC-300
Periodically check the oil level in the reservoir and keep it lled. It is not neces-
sary to replace the oil.
.
To Next Page
Loading...
