Haas 96-8000 - G187 Setting the Smoothness Level (Group 00); G188 Get Program from PST (Group 00)

200
96-8000 Rev AC
May 2010
G187 Setting the Smoothness Level (Group 00)
G-187 is an accuracy command that can set and control both the smoothness
and max corner rounding value when cutting a part. The format for using G187
is G187 Pn Ennnn.
P Controls the smoothness level, P1(rough), P2(medium), or P3(nish).
E Sets the max corner rounding value, temporarily overriding Setting 85.
Setting 191 sets the default smoothness to the user specied “rough,” “me-
dium,” or “nish” when G187 is not active. The “medium” setting is the factory
default setting. NOTE: Changing setting 191 to “Finish” will take longer to ma-
chine a part. Use this setting only when needed for the best nish.
G187 Pm Ennnn sets both the smoothness and max corner rounding value.
G187 Pm sets the smoothness but leaves max corner rounding value at its cur-
rent value. G187 Ennnn sets the max corner rounding but leaves smoothness
at its current value. G187 by itself cancles the E value and sets smoothness
to the default smoothness specied by Setting 191. G187 will be cancelled
whenever “Reset” is pressed, M30 or M02 is executed, the end of program is
reached, or E-stop is pressed.
G188 Get Program From PST (Group 00)
Calls the parts program for the loaded pallet based on the Pallet Schedule
Table entry for the pallet.