.001 F100 = F.01 .001 F100 = F.1
.0001 F1000 = F.1 .0001 F1000 = F1
78 - 5th axis Enable
When this setting is OFF, the fth axis is disabled and no commands can be
sent to that axis. See setting 30 for 4th axis. Note that there are two selections
“USER1” and “USER2” that can be used to set-up a unique rotary table.
79 - 5th-axis Diameter
This is used to set the diameter of the B-axis (0.0 to 50 inches), which the
control will use to determine the angular feedrate. The feedrate in a program
is always inches per minute (or mm per minute), therefore, the control must
know the diameter of the part being machined in the B-axis in order to compute
angular feedrate. See setting 34 for 4th axis diameter.
80 - Mirror Image B-axis
This is an On/Off setting. When it is OFF, axis motions occur normally. When it
is on, B axis motion may be mirrored (or reversed) around the work zero point.
Also see settings 45-48 and G101.
81 - Tool At Power Up
When the Power Up/Restart key is pressed, the control will change to the tool
specied in this setting. If zero (0) is specied, no tool change occurs at power
up. The default setting is 1.
Setting 81, will cause one of the following actions to occur during a Power-up/
Restart:
A. If Setting 81 is set to zero, the carousel will be rotated to pocket #1. No tool
change is performed.
B. If Setting 81 contains the tool #1, and the tool currently in the spindle is
tool #1, and ZERO RET - ALL is pressed, the carousel will remain at the same
pocket and no tool change will be performed.
C. If Setting 81 contains the tool number of a tool not currently in the spindle,
the carousel will be rotated to pocket #1 and then to the pocket containing the
tool specied by Setting 81. A tool change will be performed to change the
specied tool into the spindle.
82 - Language
Languages other than English are available in the Haas control. To change to
another language, choose a language and press Enter.
83 - M30/Resets Overrides
When this setting is On, an M30 restores any overrides (feedrate, spindle,
rapid) to their default values (100%).
84 - Tool Overload Action
This setting causes the specied action (Alarm, Feedhold, Beep, Autofeed) to
occur anytime a tool becomes overloaded (see the Tooling section).
To Next Page
Loading...
