G43 H01 Z.1 M08 X 3.365 Y-2.875
G82 Z-.175 P.03 R.1 F10. X 4.188 Y-3.313
M98 P1000 X 5.0 Y-4.0
G80 G00 Z1.0 M09 M99
T2 M06
G00 G90 G54 X.565 Y-1.875 S2500 M03
G43 H02 Z.1 M08
G83 Z-.720 Q.175 R.1 F15.
M98 P1000
G00 G80 Z1.0 M09
T3 M06
G00 G90 G54 X.565 Y-1.875 S900 M03
G43 H03 Z.2 M08
G84 Z-.600 R.2 F56.25
M98 P1000
G80 G00 Z1.0 M09
G28 G91 Y0 Z0
M30
SU b r o U t i n e S Wi t h MU l t i P l e fi x t U r e S
Subroutines can be useful when cutting the same part in different X and Y
locations within the machine. For example, there are six vises mounted on the
table. Each of these vises uses a new X, Y zero. They are referenced in the
program using the G54 through G59 work offsets. Use an edge nder or an in-
dicator to establish the zero point on each part. Use the part zero set key in the
work coordinate offset page to record each X, Y location. Once the X, Y zero
position for each workpiece is in the offset page, the programming can begin.
The gure shows what this setup would look like on the machine table. For an
example, each of these six parts will need to be drilled at the center, X and Y
zero.
Main Program Subroutine
O2000 O3000
T1 M06 X0 Y0
G00 G90 G54 X0 Y0 S1500 M03 G83 Z-1.0 Q.2 R.1 F15.
G43 H01 Z.1 M08 G00 G80 Z.2
M98 P3000 M99
G55
To Next Page
Loading...
