Haas 96-8000 - G169 5-Axis Bore and Dwell Canned Cycle (Group 09)

198
96-8000 Rev AC
May 2010
.
G166 5-Axis Bore Stop Canned Cycle
E
G98 Start
Position
G98/G99
E
Start Position
G99 Rapid Plane
Z Axis position
between holes
Feed
Rapid Move
Begin or end
of Stroke
A specic X, Y, Z, A, B position must be programmed before the canned cycle
is commanded.
Example
(Bore and Stop Cycle)
T5 M6
G01 G54 G90 X8.4221 Y-8.4221 B23. A21.342 S2200 M3 F360. (Clearance Position)
G143 H5 Z14.6228 M8
G1 X6.6934 Y-6.6934 Z10.5503 F360. (Initial Start position)
G166 E1.0 F12. (Canned Cycle)
G80
X8.4221 Y-8.4221 B23. A21.342 Z14.6228 (Clearance Position)
M5
G1 G28 G91 Z0.
G91 G28 B0. A0.
M01
G169 5-Axis Bore and Dwell Canned Cycle (Group 09)
E Species the distance from the start position to the bottom of the
hole
F Feedrate in inches (mm) per minute
P The dwell time at the bottom of the hole
A A-axis tool starting position
B B-axis tool starting position
X X-axis tool starting position
Y Y-axis tool starting position
Z Z-axis tool starting position