Haas 96-8000 - G162 5-Axis Spot Drill Canned Cycle (Group 09)

193
96-8000 Rev AC
May 2010
G & M Codes
Settings
.
E
G98 Start
Position
E
Start Position
G99 Rapid Position
G161 5-Axis Drill Canned Cycle
G98/G99
ZAxis position
between holes
Feed
Rapid Move
Beginor end
of Stroke
A specic X, Y, Z, A, B position must be programmed before the canned cycle
is commanded.
Example
( DRILL RIGHT, FRONT )
T4 M6
G01 G54 G90 X8.4221 Y-8.4221 B23. A21.342 S2200 M3 F360. (Clearance Position)
G143 H4 Z14.6228 M8
G1 X6.6934 Y-6.6934 Z10.5503 F360. (Initial Start position)
G161 E.52 F7. (Canned Cycle)
G80
X8.4221 Y-8.4221 B23. A21.342 Z14.6228 (Clearance Position)
M5
G1 G28 G91 Z0.
G91 G28 B0. A0.
M01
G162 5-Axis Spot Drill Canned Cycle (Group 09)
E Species the distance from the start position to the bottom of the
hole
F Feedrate in inches (mm) per minute
P The dwell time at the bottom of the hole
A A-axis tool starting position
B B-axis tool starting position
X X-axis tool starting position
Y Y-axis tool starting position
Z Z-axis tool starting position
A specic X, Y, Z, A, B position must be programmed before the canned cycle
is commanded.
Example
(COUNTER DRILL RIGHT, FRONT )
T2 M6
G01 G54 G90 X8.4221 Y-8.4221 B23. A21.342 S2200 M3 F360. (Clearance Position)
G143 H2 Z14.6228 M8
G1 X6.6934 Y-6.6934 Z10.5503 F360. (Initial Start position)