Haas 96-8000 - Page 267

258
96-8000 Rev AC
May 2010
Maximum Corner Rounding 225
M-Code Relays 16
M codes 16
Memory Lock 202
Memory Lock Key Switch 201
Messages 19
M-Fin 202
O
Operator Load Station 69
Operator Load Station, Pallet Changer
69
Optional Stop 22
Option Try-Out 25
Override 17
P
Pallet Changer 68, 128
Pallet Changer Recovery 67
Pallet Changer Warnings and Cautions
68
Pallet Schedule Table 71
Pallet Storage 76
Parameters 64
Parentheses ( ) 36
P-Cool 46, 204
R
Remote Jog Handle 26
Renaming Programs 36
right slash / 21
Rigid Tapping 171, 164, 228
Rotation and Scaling 155, 152
RS-232 43, 178, 229, 218
Run-Stop-Jog-Continue 24, 67
S
Searching the program 35
Second Home 16
Serial Number Engraving 148
Service 235
Settings 20
Settings, Macros 90
Shift key 21
Side Mount Tool Changer 48
Side Mount Tool Changer Recovery 55
Side Mount Tool Changer Recovery
Flow Chart 55
SMTC Recovery 55
Specications, Tool Changer 48
Spindle Air Pressure 254
Spindle Orient 202
Spindle Orientation 25
Square brackets [ ] 21
Sub Panel 13
Sub-Panel Controls 69
Sub Program 208
subprograms 121
subroutine 208
Subroutines 121
System Variables 94
T
Thread Milling 136
Time 75
Tips and Tricks 76
Tool Changer 50
Tool Changer, High Speed Side Mount
55
Tool Changer, Hydraulic 58
Tool Changer Recovery 55
Tool Changer Recovery Flow Chart,
Side Mount 48
Tool Changer, Side Mount 48
Tool Changer Specications 53
Tool Changer, Umbrella 46
Tool Holders 51
TOOL OFSET MESUR 221
transmission 204
TSC 207
TSC (Through-Spindle Coolant) 207
U
Umbrella Tool Changer 53
USB 37
W
Warm-up Compensation 227
Worklight 240
Z
Zero Return 23