113
MIDI
⓮ NOTE - OCTAVE
Sets octave shift of this zone. If an external synthesizer sound
in a diff erent octave from that you desire, adjust this parameter.
e setting range is -2 to +2.
⓯ NOTE - VOLUME
Sets the volume (Control Change #7) of this zone. However, if
CC# (20) is at “VOL”, this setting value is null.
⓰ NOTE - PAN
Sets the Pan of this zone (Control Change #10).
⓱ NOTE - VELOCITY
Sets the character of the velocity to send to this zone.
e setting range is OF and 1 to 4. At OF, the velocity is fi xed
at 100. e “touch” (velocity response) of the keyboard pro-
gresses from 1 (heavier) through 4 (lighter).
⓲ EXPRESSION - MINIMUM
⓳ EXPRESSION - MAXIMUM
Sets the range to “compress” the expression information to send
to this zone.
On the electronic organ, even if the expression pedal is fully
returned, sound does not perfectly silenced. If a GM sound
generator is used, no sound comes out. is is a parameter to
balance it.
e setting range is MIN at 0 to 63, MAX at 64 to 127.
⓴ EXPRESSION - CONTROL NUMBER
Sets the MIDI control change number (CC#) of the expression
pedal.
e way of controlling volume diff ers type by type of the MIDI
equipment to be connected. is parameter is for setting a
proper number to control the volume of the connected MIDI
equipment.
You can select 7: VOL, 11: EXP.
MESSAGE - DAMPER
Sets whether to send the damper information to this zone.
NOTE: The parameters in these modes are patch parameters, and
are recorded to the patch.
PANIC FUNCTION AND PARAMETER RE-LOAD
If a problem occurs to the MIDI system, it may be caused by a
cypher. When this keyboard and an external MIDI equipment
is connected, such a problem could happen due to the diff er-
ence between the setting contents of both equipment.
In such a case, touch both [S], [T] buttons. Both the “All
Note Off ” and “Reset All Controllers” are sent to the MIDI
channels of all external zones (Panic Function), then the set-
tings of all external zones are reloaded (sent again).
⓳⓴
To Next Page
Loading...
Need help?
General
