93
Setting the Parameters
Tremolo
e Tremolo modulates the volume at a set cycle.
❺ TREMOLO - WAVEFORM
Sets which waveform is used to modulate the volume.
Tri: Triangle wave. The volume changes smoothly.
Sqr: Square wave. The volume suddenly rises and falls.
Saw: Sawtooth wave. Repeated decaying sound is obtained.
S&H: Sample & hold. The volume changes randomly.
DSqr: Dull square wave like the old electric piano e ect.
❻ TREMOLO - RATE
Adjusts the speed of the tremolo cycle.
e setting range is 0 to 127. e higher the value rises, the faster the cycle becomes. is
is synchronized with the [EFFECT AMOUNT] knob on the top panel.
❼ TREMOLO - DEPTH
Adjusts the depth of the tremolo eff ect.
e setting range is 0 to 127. At 0 the volume does not modulate. e higher the value
goes up, the deeper becomes the eff ect. At 127 a repeated no sound/maximum volume
is obtained.
Auto Pan
Auto Pan applies adjustable modulation to the stereo fi eld.
is is not applicable if a monophonic (one channel) amp is used, or when the Leslie
eff ect is used.
❹❺❻❼
❹❺❻❼
❺ AUTO PAN - WAVEFORM
Sets which waveform to modulate the direction.
Tri: Triangle wave. The direction smoothly changes.
Sqr: Square wave. The direction suddenly moves to the left, and suddenly moves to the right.
Saw: Sawtooth waveform. The direction repeatedly moves from left to right.
S&H: Sample & hold. The direction changes randomly.
DSqr: Dull square wave like the old electric piano e ect (recommended).
❻ AUTO PAN - RATE
Adjusts the speed of the modulation.
e setting range is 0 to 127. e higher the value rises, the faster the modulation be-
comes. It is linked with the [EFFECT AMOUNT] on the top panel.
❼ AUTO PAN DEPTH
Adjusts the depth of the cycle.
e setting range is 0 to 127. At 0, there is no direction modulation. e higher the value
rises, the deeper the eff ect becomes. At 127 you can give a perfect left/right repetition.
Time
Left Right
Depth
Rate
Level
Time
Depth
Rate
NOTE: All the parameters in these modes
are Patch Parameters. They are re-
corded into the Patch.
To Next Page
Loading...
Need help?
General
