Hammond SK2 - Custom Tone-Wheel Procedures; Saving Custom Tone-Wheel Files

125
Save the Setup
CUSTOM TONEWHEEL PROCEDURES
Save or Load the Custom Tone-Wheels to/from the USB fl ash drive in the CUST. TW mode, not SETUP mode on previous page.
To locate this mode:
HOW TO READ THE DISPLAY
SAVE THE CUSTOM TONEWHEEL FILE
Check that the USB fl ash drive is correctly inserted.
Locate the fi le mode by pressing [W] button.
WHAT DOES THIS MEAN?
USB is not ready.
USB fl ash drive is not correctly inserted.
Select the “New File” by pressing the [S] button (or turning
the [VALUE] knob) a few times.
If you press the [ENTER] button, it is saved.
WHAT DOES THIS MEAN?
Same name exists.
 ere is a fi le with same name already. Change the Custom
name on the SK, or delete the fi le with same name in the USB
fl ash drive (next page).
A fi le name same as Custom name is automatically given to the
saved Custom Tonewheel fi le.
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
Choose the Custom Tonewheel which you wish to save.
MENU/
EXIT
ENTER
CUSTOM name
This indicates there is another
Custom Tonewheel  le above
(or below).
Type of File
TW: Tonewheel
What your are going to operate
This indicates there is another
page on the right (or on the left).
1
3
4
5
6
2