Hammond SK2 - Loading Custom Tone-Wheel Files; Deleting Custom Tone-Wheel Files

*#1
Sk1
/
Sk2
Owner’s Manual
126
LOAD THE CUSTOM TONEWHEEL
FILE
Locate the Custom Number mode with refer to upper fi gure
on last page.
Select the Custom Tonewheel fi le to load with the [S],[T]
buttons or the [VALUE] knob, and press [ENTER].
 If you do this operation, a patch in this keyboard are
replaced with the newly loaded patch. You should
save important data beforehand (p. 125).
Check the USB fl ash drive is correctly inserted.
Select the Custom number to be replaced.
Press the [ENTER] button.  e Custom Tonewheel is loaded.
 e Tonewheel set name is shorted in this page. Please refer
below for detail.
B1: B-Type 1
B2: B-Type 2
Ml: Mellow
DELETE THE CUSTOM TONE-
WHEEL FILE
Check the USB fl ash drive is correctly inserted.
Select the Custom Tonewheel fi le to delete with the [S],[T]
buttons or the [VALUE] knob.
Press [W] button once. “[ENT] to Delete” is displayed.
Press the [ENTER] button. “Delete?” is displayed. Now press
the [ENTER] button again.  e Tonewheel fi le is deleted.
NOTE: If you do not with to delete the setup, touch the [MENU/EXIT]
button.
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
UPPER
PEDAL
LOWER
NUMBER NAME
PAT CH
ENTER
VA L U E
To locate the Custom Tonewheel mode, please refer to the il-
lustration or top of page 125.
1
2
3
4
1
2
3
4
5