66 MIDI
Hammond XK-2 Quick Features Guide
Select
EDIT PARAMETER
{10 MIDI1
UM CHANNEL 1
{22 MIDI13
DB CHANGE ON
MIDI Drawbar Change
This Advanced Feature allows you to turn the MIDI Drawbar Change Gate "ON" or "OFF.” When this switch is "ON,”
incoming Drawbar changes made during performance (Controllers #50, 51 & 52) are recognized by the XK-2. (These are
treated separately from the other Controllers such as Volume, Modulation, Expression, etc. See the next page for
information about MIDI Control Change. See the MIDI Controller list for a complete listing of Controllers.) When this
switch is "OFF,” the XK-2 ignores incoming Drawbar Changes. The default setting is “ON.”
TRY THIS:
1. Touch the EDIT Select Touch Button. The red LED will light, and the Information Center Display
should look like this:
2. Touch the SYSTEM Select Touch Button two times. The Information Center Display should look like
this:
3. Touch the PAGE “<” Select Touch Button twelve times. The Information Center Display should look
like this:
4. Now select the option you wish by doing the following:
Use either the VALUE ">" or the VALUE "?" Select Touch Button to turn Drawbar Change "ON" or "OFF.”
This is a System Parameter, and this data CAN NOT be stored to a Preset. To see a total listing of all System Parameters, see the System
Parameter List.
NOTE: You can exit by touching the EDIT Select Touch Button.
To Next Page
Loading...
