Hammond XK-2 - Key Map

79MIDI
Hammond XK-2 Quick Features Guide
Select
EDIT PARAMETER
}43 ZONE1-1
CHANNEL OFF
}47 ZONE1-5
KEY MAP LO 1C
Ë External Zone Key Map
This Advanced Feature allows you to set the Low and High note ranges for the External Zones.
TRY THIS:
1. Touch the EDIT Select Touch Button. The red LED will light, and the Information Center Display
should look like this:
2. Touch the INT.CONT./EXT.ZONE Select Touch Button two times. The Information Center Display
should look like this:
3. Touch the PAGE ”<” Select Touch Button four times.
The Information Center Display should look like this:
4. Now select the option you wish by doing the following:
Use the INT.CONT./EXT ZONE Select Touch Button to select EXT. ZONE 1 or EXT. ZONE 2.
NOTE: When you touch the INT.CONT./EXT.ZONE Select Touch Button repeatedly, you are actually toggling
between the INT.CON T. and EXT.ZONE Menus. As a result, you will also see the SPLIT Menu display along with
EXT.ZONE 1 and EXT.ZONE 2.
Use the PAGE “<” and “=” Select Touch Buttons to select either “LO” (the lower limit of the zone) or “HI” (the upper
limit of the zone).
Use the VALUE ">" Select Touch Button to scroll up through the choices.
Use the VALUE "?" Select Touch Button to scroll down through the choices.
This is a System Parameter, and this data CAN NOT be stored to a Preset. To see a total listing of all System Parameters, see the System
Parameter List.
NOTE: You can exit by touching the EDIT Select Touch Button.