Hammond XK-2 - Transmit Bender Data on; off

68 MIDI
Hammond XK-2 Quick Features Guide
Select
EDIT PARAMETER
{10 MIDI1
UM CHANNEL 1
{24 MIDI15
Tx BENDER ON
MIDI Transmit Bender Data ON / OFF
This Advanced Feature allows you to select whether you want a connected MIDI instrument to receive Pitch Bend data sent
from the XK-2. When this switch is "ON,” Pitch Bend data will be sent from the XK-2 when the Pitch Bend Wheel is
moved. When this switch is "OFF,” the XK-2's Pitch Bend Wheel can still be used to bend the internal sounds of the XK-2;
however, Pitch Bend data will be transmitted through the MIDI OUT connector to a connected MIDI instrument. The
default setting is “ON.”
TRY THIS:
1. Touch the EDIT Select Touch Button. The red LED will light, and the Information Center Display
should look like this:
2. Touch the SYSTEM Select Touch Button two times. The Information Center Display should look like
this:
3. Touch the PAGE “<” Select Touch Button fourteen times. The Information Center Display should look
like this:
4. Now select the option you wish by doing the following:
Use either the VALUE ">" or the VALUE "?" Select Touch Button to turn this feature "ON" or "OFF.”
This is a System Parameter, and this data CAN NOT be stored to a Preset. To see a total listing of all System Parameters, see the System
Parameter List.
NOTE: You can exit by touching the EDIT Select Touch Button.