Hammond XK-2 - Bender

84 MIDI
Hammond XK-2 Quick Features Guide
Select
EDIT PARAMETER
}43 ZONE1-1
CHANNEL OFF
}53 ZONE1-11
BENDER ON
Ë External Zone Bender (Pitch Bend)
This Advanced Feature allows you to select whether you want to transmit Pitch bend data to a connected MIDI instrument.
The default setting is "ON.”
TRY THIS:
1. Touch the EDIT Select Touch Button. The red LED will light, and the Information Center Display
should look like this:
2. Touch the INT.CONT./EXT.ZONE Select Touch Button two times. The Information Center Display
should look like this:
3. Touch the PAGE ”<” Select Touch Button ten times.
The Information Center Display should look like this:
4. Now select the option you wish by doing the following:
Use the INT.CONT./EXT ZONE Select Touch Button to select EXT. ZONE 1 or EXT. ZONE 2.
NOTE: When you touch the INT.CONT./EXT.ZONE Select Touch Button repeatedly, you are actually toggling
between the INT.CON T. and EXT.ZONE Menus. As a result, you will also see the SPLIT Menu display along with
EXT.ZONE 1 and EXT.ZONE 2.
Use either the VALUE ">" or the VALUE "?" Select Touch Button to turn this function “ON” or “OFF,”.
This is a System Parameter, and this data CAN NOT be stored to a Preset. To see a total listing of all System Parameters, see the System
Parameter List.
NOTE: You can exit by touching the EDIT Select Touch Button.