Happy HCH - Table of Contents

-SJ -3
INDEX
IMPORTANT SAFETY INSTRUCTIONS .. 1-1
WARNING LABELS & THEIR LOCATIONS ..... 1-2
SETTING UP THE MACHINE
Remove the machine from box............... 2-1
Accessories ............................................ 2-2
Assemble machine unit .......................... 2-3
Machine installation ................................ 2-4
Grounding instruction ............................. 2-6
Disposal of a battery ............................... 2-6
MAIN PARTS ............................................ 3-1
THE CONTROL BOX ................................ 3-3
DRIVE MODE ........................................... 3-4
INSERTING A NEEDLE ............................ 4-1
SELECT NEEDLES AND THREADS....... 4-2
BACKING MATERIALS............................. 4-3
BOBBIN WINDING
Winding the bobbin ................................. 4-4
Removing the bobbin.............................. 4-5
Inserting the bobbin ................................ 4-5
Adjusting bobbin thread tension ............. 4-5
Inserting the bobbin case ....................... 4-5
THREADING THE MACHINE
How to thread upper thread .................... 4-6
HOW TO READ THESE INSTRUCTIONS and SCROLLBAR 4-8
DISPLAYING THE PATTERN IN SETTING MODE... 4-9
TURNING THE MACHINE ON
How to turn on the machine.................... 5-1
Calendar and clock setting ..................... 5-2
MESSAGE ................................................ 5-3
PREPARATION OF PATTERN DATA
Connecting to a PC ................................ 5-4
Reading embroidery pattern data from
the PC .......................................................... 5-4b
Read embroidery pattern data ................ 5-5
Reading pattern data .............................. 5-6
Selection of folders ................................. 5-9
How to select patterns from memory ...... 5-A
Erasing patterns from memory ............... 5-B
NEEDLE BAR SELECTION ...................... 5-E
SEWING WITH TUBULAR FRAMES
Installing and removing the frame base .. 6-1
How to hoop ........................................... 6-2
Putting the hoop on the machine ............ 6-3
Starting to embroider .............................. 6-4
CAP FRAME (OPTION)
Changing the needle plate...................... 7-1
Installing and removing the cap drive frame... 7-2
Normal cap frame ................................... 7-5
Wide cap frame ...................................... 7-8
Starting to embroider .............................. 7-B
ADJUSTING THE THREAD TENSIONS .. 8-1
SEWING
What to do if the thread breaks while sewing . 9-1
Stopping and resuming sewing .............. 9-1
Loss of power while embroidering .......... 9-2
Moving the hoop while embroidering and then returning to
the correct location (Position) .......................................
9-3
Moving back to the starting point (Origin) 9-3
Going back to the beginning of the design (Top) .... 9-4
Placing the design in the center of the selected
embroidery frame
(Center) .................................. 9-4
Rotating and mirroring designs (Convert) .. 9-5
Starting in the middle of a design (Position) ... 9-6
POSITION ALIGNMENT BY DEFINING 2 POINTS... 9-8
POSITION ................................................. 9-B
Piece number ......................................... 9-C
REGISTER ................................................ 9-D
Entry ....................................................... 9-E
Return ..................................................... 9-F
READING
Join ....................................................... 10-1
Pattern Read Settings .......................... 10-4
0_1 O212
0-1