-DA -60
9-2
SEWING
9_2 O901
Loss of power while embroidering
If you have a power failure while embroidering, follow these instructions and you can restore the
position of the frame and the pattern data to its state before the failure.
1. Turn on the power switch.
2. Press
.
3. Press
.
4. Press .
The main shaft will make one rotation and stop at
the "C" point (proper stop position).
5. Press .
The needle will go down and trim the thread.
6. Press .
After the carriage and frame move slightly, the
embroidery frame will return to the previous
position automatically.
7. Press and back up several stitches
from the stop point by pressing the 3-4
times.
8. Press
.
9. Start sewing again by pressing the .
ON
OFF
E-050 C point
OK
CAUTION: To prevent accidents.
When performing a thread trim, be careful of
the needle which will pierce the fabric.
CAUTION: To prevent accidents.
The frame moves quickly.
Keep your hands and body clear of the ma-
chine.
To Next Page
Loading...
