ACO6800+ Installation and Operation Manual 113
Copyright © 2009, Harris Corporation
Appendix A: Communication and Control Troubleshooting Tips
The module does not seem to work.
Solutions
• Ensure the correct frame is powered up.
• Verify that all appropriate rear connections are secure.
• Gently push the module into its slot in the frame to ensure it is seated
properly.
• Ensure the back module does not have bent pins by following this
procedure:
a. Unplug the front module.
b. Unscrew and remove the back module.
c. Inspect the spring connector at the bottom of the back module
(Figure A-1), and verify the connector does not have any slightly bent
or pressed pins.
d. Carefully reposition any bent pins; if this is not possible, contact
Customer Service.
To Next Page
Loading...