ACO6800+ Installation and Operation Manual 47
Copyright © 2009, Harris Corporation
Chapter 5
ACO6800+DSD Parameters, LEDs, and
Alarms
On-Screen Display Monitoring
If you are using card-edge controls to configure your ACO6800+DSD module,
you can use the on-screen display (OSD) monitoring feature to view the current
parameter selections. When the OSD monitoring is activated, the current
parameter selections are displayed on module’s monitoring outputs. For
information on enabling OSD monitoring, see “Activating On-Screen Display”
on page 19.
Parameter Table Notes
When you look at the control parameter tables, note the following:
• Shaded table rows and [RO] after the parameter name indicate read-only
(feedback) parameters.
• Bolded parameter options indicate the default settings for the parameter.
• The bank selection and rotary switch combinations for each parameter and
parameter option are listed in the tables under the Bank, Switch heading.
For more information about using the card-edge controls, see “Card-Edge
Controls” on page 18.
• The parameters are listed in the order that they appear in CCS Navigator.
To Next Page
Loading...