Harris ACO6800+ISD - Chapter 8: ACO6800+ISCST Parameters, Leds, and Alarms; On-Screen Display Monitoring; Parameter Table Notes; Cross-Functional Parameter Changes

ACO6800+ Installation and Operation Manual 85
Copyright © 2009, Harris Corporation
Chapter 8
ACO6800+ISCST Parameters, LEDs, and
Alarms
On-Screen Display Monitoring
If you are using card-edge controls to configure your ACO6800+ISCST
module, you can use the on-screen display (OSD) monitoring feature to view
the current parameter selections. When the OSD monitoring is activated, the
current parameter selections are displayed on module’s monitoring outputs. For
information on enabling OSD monitoring, see “Activating On-Screen Display”
on page 19.
Parameter Table Notes
When you look at the control parameter tables, note the following:
• Shaded table rows and [RO] after the parameter name indicate read-only
(feedback) parameters.
• Bolded parameter options indicate the default settings for the parameter.
• The bank selection and rotary switch combinations for each parameter and
parameter option are listed in the tables under the Bank, Switch heading.
For more information about using the card-edge controls, see “Card-Edge
Controls” on page 18.
• The parameters are listed in the order that they appear in CCS Navigator.
Cross-Functional Parameter Changes
When you configure certain parameters on an ACO6800+ISCST module, you
force a change in other associated parameters. These cross-functional parameter
changes for are described in Table 8-1.