ACO6800+ Installation and Operation Manual 23
Copyright © 2009, Harris Corporation
Chapter 3: Configuration and Operation
Manual Control
When the switching is not triggered by other higher priority events, you can use
the parameters described in Table 3-4 to manually switch the source using either
CCS Navigator or the card-edge controls.
Table 3-3. GPI Input Control
GPI Action/Result
GPI 1 Switches output source to IN 1
GPI 2 Switches output source to IN 2
Table 3-4. Manual Switch Parameters
Parameter Name
Bank,
Switch
Function Options
ACO6800+ISD
Group A Manual Switch 1, E Sets the output source when a channel is
switched manually
• Disable
• Switch to A1
• Switch to A2
ACO6800+DSD and ACO6800+IDSD
Group A Manual Switch 1, E Sets the output source when a channel is
switched manually
• Disable
• Switch to A1
• Switch to A2
Group B Manual Switch 4, E Sets the output source when a channel is
switched manually
• Disable
• Switch to B1
• Switch to B2
ACO6800+ASID
Manual Switch n/a Sets the output source when a channel is
switched manually
• Disable
• Switch to 1
• Switch to 2
ACO6800+ISCST
Manual Switch 1, E Sets the output source when a channel is
switched manually
• Disable
• Switch to A1
• Switch to A2
To Next Page
Loading...